Tddragon Posted November 3, 2020 Report Share Posted November 3, 2020 27 minutes ago, Shred Gruumer said: Whats better than one.... Two Oxessesesses Absolutely gorgeous! I will be getting the Virus Centurion skis for this winter 1 Link to comment Share on other sites More sharing options...
pokkis Posted November 3, 2020 Report Share Posted November 3, 2020 How you attach them together when you come down the slope 49 minutes ago, Shred Gruumer said: Whats better than one.... Two Oxessesesses 1 Link to comment Share on other sites More sharing options...
Tddragon Posted November 3, 2020 Report Share Posted November 3, 2020 1 minute ago, pokkis said: How you attach them together when you come down the slope MacGyver style. Duct tape! 2 Link to comment Share on other sites More sharing options...
west carven Posted November 3, 2020 Report Share Posted November 3, 2020 howdy mods should skiers be banned from this forum? … haha! 1 Link to comment Share on other sites More sharing options...
ThePeonsChamp Posted November 3, 2020 Report Share Posted November 3, 2020 Can't wait to try this bad boy out. 165 CC+ 23.5w 10ish? Scr. Didn't have a smaller wide hardboot all mountain stick yet for my larger feet so I am super stoked to try this out. 8 Link to comment Share on other sites More sharing options...
crackaddict Posted November 11, 2020 Report Share Posted November 11, 2020 NeverSummer West Bound 157 DF... 28.0mm waist!!! I have high expectations for this beauty. I'm so psyched not to have to choose between a carving board and a freeride board anymore! 1 Link to comment Share on other sites More sharing options...
noschoolrider Posted November 11, 2020 Report Share Posted November 11, 2020 On 11/3/2020 at 6:54 AM, Shred Gruumer said: Whats better than one.... Two Oxessesesses One snowboard and one girl? Or, two Kesslers? Or, the local lodge covered with race boards? 4 Link to comment Share on other sites More sharing options...
crackaddict Posted November 12, 2020 Report Share Posted November 12, 2020 (edited) Oh ya... This one too. Jasey-Jay TCX 166 T4 titanal soft boot carver! 17 metre average radius, 30cm waist, stiff as ****... This one was a bit of of a collaboration between Bruce Varsava, Jasey-Jay Anderson, and John Gibson. Bruce had so sell Jasey-Jay on the contra sidecut idea, John had to design the actual sidecut, and Jasey-Jay built the board. Thanks again to the team! This is my third custom board with a 30cm plus waist. I think this is the one I've been waiting for. I hope that with this design and the advanced materials and construction techniques, I'll finally be able to figure out this soft boot carving thing... Look out @Ryan Knapton here I come, and I've got the stance for a beautiful heelside! Edited November 12, 2020 by crackaddict 5 Link to comment Share on other sites More sharing options...
west carven Posted November 12, 2020 Report Share Posted November 12, 2020 howdy crackaddict you know what they say about big feet … hehe … what is your stance width and front/back angles? that is a great looking board with some fine collaborators … 24cm waist for me is plenty ... Link to comment Share on other sites More sharing options...
Allee Posted November 12, 2020 Report Share Posted November 12, 2020 That doesn't look like it would be any fun at all, James. Remind me not to fall into your trenches if I bring the Exigy to Revy this season. Link to comment Share on other sites More sharing options...
slopestar Posted November 12, 2020 Report Share Posted November 12, 2020 1 hour ago, west carven said: howdy crackaddict you know what they say about big feet … hehe … what is your stance width and front/back angles? that is a great looking board with some fine collaborators … 24cm waist for me is plenty ... Check out the smaller alloys alloysnow.com AZX and DO Link to comment Share on other sites More sharing options...
lowrider Posted November 12, 2020 Report Share Posted November 12, 2020 On 11/11/2020 at 5:03 PM, noschoolrider said: One snowboard and one girl? Or, two Kesslers? Or, the local lodge covered with race boards? Link to comment Share on other sites More sharing options...
Atom Ant Posted November 13, 2020 Report Share Posted November 13, 2020 @crackaddict Please let us know how that board rides. Mitch Link to comment Share on other sites More sharing options...
crackaddict Posted November 14, 2020 Report Share Posted November 14, 2020 On 11/13/2020 at 12:17 PM, Atom Ant said: Please let us know how that board rides. Will Do! On 11/12/2020 at 2:07 PM, west carven said: what is your stance width and front/back angles? Howdy West! 22.75 inches wide, 9 and 27 degrees for softboot carving, -3 and 18 for freeride and powder boards. Nine degrees is as low as I can go on the backfoot and still get smooth deep heelside carves. And by the way, it's not about huge feet, the width is necessary for extreme angulation. With a 17m sidecut at such a short length I'm going to have to tip it up real high to turn tight enough to keep it under control on the steeps. The NeverSummer is not as wide but the extra sidecut (about 9m SCR) means it's almost as wide under the bindings and it won't require as much angulation. I expect that one will be better suited to slower carving on mellow terrain. On 11/12/2020 at 2:08 PM, Allee said: if I bring the Exigy to Revy this season. Allee! It would be great to see you here. I'll ride my Exegi too! No promises about the trenches but there's always plenty of clean cord when it's not snowing... Link to comment Share on other sites More sharing options...
b.free Posted November 15, 2020 Report Share Posted November 15, 2020 (edited) Probably the best customly built board I ever had. My new toy Virus Phantom 205. Edited November 15, 2020 by b.free 8 Link to comment Share on other sites More sharing options...
Tddragon Posted November 15, 2020 Report Share Posted November 15, 2020 (edited) 4 hours ago, b.free said: Probably the best customly built board I ever had. My new toy Virus Phantom 205. Now THIS is proper board porn! 205cm oh my! Edited November 15, 2020 by Tddragon 2 Link to comment Share on other sites More sharing options...
softbootsurfer Posted November 15, 2020 Report Share Posted November 15, 2020 Wishing and a hoping for Snow...leaning against the mud room wall, a new 161 Burton Sensei 4 Link to comment Share on other sites More sharing options...
*Ace* Posted November 16, 2020 Report Share Posted November 16, 2020 @b.free when did Frank release this sweet thing? Looks amazing! Also, you have it out in early season conditions at Abasin? How is shangri-la looking this year? @softbootsurfer I am anxiously awaiting the pictures of the lines this board will be producing. Link to comment Share on other sites More sharing options...
b.free Posted November 16, 2020 Report Share Posted November 16, 2020 @*Ace*, Frank built it for me this September. Great carving board. Snow is very good at Abasin right now. Just not much of terrain open, only High noon is grommed and open right now. 1 Link to comment Share on other sites More sharing options...
west carven Posted November 19, 2020 Report Share Posted November 19, 2020 howdy crackaddict just remembered your last years new board porn … the 194 t4 contra … how did that ride? Link to comment Share on other sites More sharing options...
Shred Gruumer Posted November 20, 2020 Report Share Posted November 20, 2020 (edited) As Jack said... "There can be only one"! I guess we will see. A special thanks to IVAN at i-carve.com, he is top notch and very easy communication. Purchasing is simple!! Do not hesitate to reach out, purchasing globally these days is easy and fun.. my board was at my door in 3 days! better than 90% of buying in USA... amazing.. typical custom fees are around the 40 to 50 dollar mark for a high end purchase. Thanks again Ivan! Edited November 20, 2020 by Shred Gruumer 5 1 Link to comment Share on other sites More sharing options...
Jack M Posted November 20, 2020 Report Share Posted November 20, 2020 36 minutes ago, Shred Gruumer said: As Jack said... "There can be only one"! I guess we will see. A special thanks to IVAN at i-carve.com, he is top notch and very easy communication. Purchasing is simple!! Do not hesitate to reach out, purchasing globally these days is easy and fun.. my board was at my door in 3 days! better than 90% of buying in USA... amazing.. typical custom fees are around the 40 to 50 dollar mark for a high end purchase. Thanks again Ivan! Agreed all around. Indeed if I could only have one board, this is "the one". Simply my favorite in 30 years of carving. So far! 1 Link to comment Share on other sites More sharing options...
GeoffV Posted November 20, 2020 Report Share Posted November 20, 2020 Welcome to the K-168 club Shred. 1 Link to comment Share on other sites More sharing options...
Tddragon Posted November 20, 2020 Report Share Posted November 20, 2020 On 11/3/2020 at 1:59 PM, west carven said: howdy mods should skiers be banned from this forum? … haha! 2 hours ago, Shred Gruumer said: As Jack said... "There can be only one"! I guess we will see. A special thanks to IVAN at i-carve.com, he is top notch and very easy communication. Purchasing is simple!! Do not hesitate to reach out, purchasing globally these days is easy and fun.. my board was at my door in 3 days! better than 90% of buying in USA... amazing.. typical custom fees are around the 40 to 50 dollar mark for a high end purchase. Thanks again Ivan! Nice! I got a used Kessler Alpine 180 that was custom made for someone else thats my weight - right before the shutdown this year... so cant wait to try it this season... counting the minutes till we have snow here in Mass:) Link to comment Share on other sites More sharing options...
GeoffV Posted November 21, 2020 Report Share Posted November 21, 2020 On 11/20/2020 at 11:41 AM, Tddragon said: Nice! I got a used Kessler Alpine 180 that was custom made for someone else thats my weight - right before the shutdown this year... so cant wait to try it this season... counting the minutes till we have snow here in Mass:) I was at Wachusett yesterday Link to comment Share on other sites More sharing options...
Recommended Posts