Jump to content
Note to New Members ×

Looking for ski/board plastic boot tongues at ATC


Corey

Recommended Posts

Not very picky, just trying to spread the pressure up a bit at the top of my boot tongue.  This will be cut/trimmed so only the top 3-4" of plastic is inside my boot.  The bottom can be damaged/missing/whatever.  One or two, I'll take whatever.  

 

I'm getting a pressure point on my shin where the UPZ tongue ends.  The liner extends up 2-3" above that tongue, but the pressure point still exists.  I used a piece of an old boot but it's cracking from being really old and oxidized.  

Link to comment
Share on other sites

Err, setup away from pressure....

More forward tilt, either underfoot or forward tilt with the boots.

 

My conformable liners (UPZ's) extend higher than stock liners, not to mention the custom foamed liner. Have a hard liner tongue and are like slippers, with no heel slip or packing out.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...