Guest kriss Posted October 24, 2005 Report Share Posted October 24, 2005 can someone provide a simple explanation regarding the use of the 0,3,6 cant disks with the td2 standards? what is the purpose of the cant and what will using one over the other will do? what is the effect of using them on the front and rear bindings? thanks. Quote Link to comment Share on other sites More sharing options...
bobdea Posted October 24, 2005 Report Share Posted October 24, 2005 http://www.alpinecarving.com/binding_setup.html#cant Quote Link to comment Share on other sites More sharing options...
Slow Eddie Posted October 24, 2005 Report Share Posted October 24, 2005 There are also very good articles on this site - one that is specific to TD2's and an earlier one devoted to TD1's. Both well-explained by one of the forum moderators, and reading the Td1 article will shed some light on the reasoning behind the evolution into the TD2. Hope this helps. Quote Link to comment Share on other sites More sharing options...
Mike T Posted October 24, 2005 Report Share Posted October 24, 2005 http://www.yyzcanuck.com/E_tech_article04.htm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.