michael.a Posted December 23, 2011 Report Share Posted December 23, 2011 Seems obvious but... When centering your boots on bindings, how to you actually find the center of the boot? Some boots have an arrow as a reference, but none of my boots do. I always roughly measured from one end of the boot to the other, divided by 2 and voila. However I just heard someone tell me that finding the middle of a boot is a bit more complicated and should take into account how the liners sit in the shell, i.e., find the center by using your liners and mark the spot, put em back in, and then see where you foot is centered in the boot. To me it sounds almost the same, anyone care to comment? Quote Link to comment Share on other sites More sharing options...
pokkis Posted December 23, 2011 Report Share Posted December 23, 2011 Way we do it: http://www.extremecarving.com/forum/viewtopic.php?t=7172&start=0&postdays=0&postorder=asc&highlight=fuego+test Quote Link to comment Share on other sites More sharing options...
michael.a Posted December 23, 2011 Author Report Share Posted December 23, 2011 This is more about binding bias than choosing binding angles... Quote Link to comment Share on other sites More sharing options...
lafcadio Posted December 23, 2011 Report Share Posted December 23, 2011 I always make sure that my toe and heel are both at the edge of the board (similar to Fuego test). I once found after setting up my bindings carelessly, my foot was shifted more toward toeside and I had all kinds of problems until I realized it and corrected the setup. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.