Flyin Hawaiian Posted February 10, 2008 Report Share Posted February 10, 2008 Looking for heel and toe lifts for Burton plates and canting discs. Quote Link to comment Share on other sites More sharing options...
brice540iit Posted February 10, 2008 Report Share Posted February 10, 2008 Hey I've got one that i don't use right now. Quote Link to comment Share on other sites More sharing options...
mr_roboteye Posted February 11, 2008 Report Share Posted February 11, 2008 I've got a heel and toe lift kit, (factory burton) that I'll never use, so it might as well go to a good home. PM me your mailing address. later, Dave R. Quote Link to comment Share on other sites More sharing options...
BlueB Posted February 11, 2008 Report Share Posted February 11, 2008 Dave, If Hawaiian didn't take it I would. I was just about to cut some out of cutting board... Is this the type that you slip under the toe/heel blocks? Boris Quote Link to comment Share on other sites More sharing options...
mr_roboteye Posted February 11, 2008 Report Share Posted February 11, 2008 It's a lift block that's two pieces, there's teeth that allow you to cant as well as lift, or you can keep it at zero and just lift. (toe or heel) If hawaiian doesn't bite you can have them. Got any burton 4x4 aluminum discs? later, Dave R. Quote Link to comment Share on other sites More sharing options...
BlueB Posted February 11, 2008 Report Share Posted February 11, 2008 Got any burton 4x4 aluminum discs? Wish I had for myself... Only plastic c**p. Are going to ride a bit with Cypress crew, this year? Quote Link to comment Share on other sites More sharing options...
mr_roboteye Posted February 11, 2008 Report Share Posted February 11, 2008 Mr. Hawaiian sent me his address, sorry Boris. I just ride / ski at Whistler/Blackcomb. No offence, but the local hills are just too small. later, Dave R Quote Link to comment Share on other sites More sharing options...
mr_roboteye Posted February 13, 2008 Report Share Posted February 13, 2008 Lift / cant kit mailed today after work (tues) via airmail. Enjoy, Dave R. Quote Link to comment Share on other sites More sharing options...
mr_roboteye Posted March 1, 2008 Report Share Posted March 1, 2008 Have you got the stuff yet? It should have gotten there by now. later, Dave R. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.