Jump to content

starcarver

Member
 View Profile  See their activity

  • Posts

    213

  • Joined

  • Last visited

 Content Type 

Posts posted by starcarver

  3. TD3 Step-in’s vs Burton race plates “center of gravity”

    in Carving Central

    Posted

    I have three sets TD3 step in’s with 0 degree cant disk on my boards, but the TD3’s are very high off the board compared to my standard Burton race plates.

     

    The TD3 puts the boots one inch higher than the Burton Race plates. See pic

     

    I am trying to lower the center of gravity. All of the EC and Pureboarders seem to run no cant or lift. 

     

    But I would still like to use my Intec (Fintec heels).

     

    Is there a low profile Intec binding?

     

    post-3652-0-22165200-1421795246_thumb.jp

  8. Binding question

    in Carving Central

    Posted

    Dose any binding manufacture make a binding that is as low profile as the Burton race plates but with a Intec step-in heal.?

    I have boxes full of TD bindings and even with the 0 degree base they are significantly higher than the plane of the deck compared to Burton race plates.

    I would still like to use my intec/Fintec heels

    Thanks

  11. Stripped inserts

    in Carving Central

    Posted

    thanks for the ideas guys.

    as for the seller ...it is physically to late for him to make this right as it was a time sensitive purchase. my vacation started two hours ago and now I am on the way to "home depot" instead of on the road to the mountains....

    i am not mad at the seller, I made the choice not to buy a new board from a reputable dealer. we create our own destiny :)

×
×
  • Create New...