DiveBomber Posted March 17, 2006 Report Share Posted March 17, 2006 just looking for some opinions Quote Link to comment Share on other sites More sharing options...
Sinecure Posted March 19, 2006 Report Share Posted March 19, 2006 What do you mean? You mean cant? I use the 3 degree cant in front, with pure toe lift and 6 degree in rear with mostly heel lift, but some inward cant. There are loads of discussions here on cant/lift. Quote Link to comment Share on other sites More sharing options...
Gecko Posted March 19, 2006 Report Share Posted March 19, 2006 What do you mean? You mean cant? I use the 3 degree cant in front, with pure toe lift and 6 degree in rear with mostly heel lift, but some inward cant. There are loads of discussions here on cant/lift. Thats about the same as what I run only I don't use any can't just lift Quote Link to comment Share on other sites More sharing options...
philfell Posted March 19, 2006 Report Share Posted March 19, 2006 I ride front foot flat, some ride with slight toe lift (3 degrees is usually the norm, it you are going to use toe lift) Quote Link to comment Share on other sites More sharing options...
D-Sub Posted March 19, 2006 Report Share Posted March 19, 2006 wow, DiveBomber...you're on fire with the thread starts! I did some a/b this week, and found I prefer FLAT front foot (no lift, no cant) on my "freeride" board (Prior 4WD) and 3* toe lift with slight cant on my full carver (Prior WCR) 3* lift/cant in the back, or whatever that equates to on TD2s Quote Link to comment Share on other sites More sharing options...
DiveBomber Posted March 19, 2006 Author Report Share Posted March 19, 2006 well i have my rear binding with quite a bit of heel lift, slight inward cant, front maybe like 3deg toe lift and a hair of inward cant. i had more inward cant on the rear and less front toe lift, but it fell like it was pulling my legs apart and harder to twist at the waist not sure on the exact specs since they are cateks Quote Link to comment Share on other sites More sharing options...
philfell Posted March 19, 2006 Report Share Posted March 19, 2006 What do you mean by "twist at the waist"?? How wide is your stance. Quote Link to comment Share on other sites More sharing options...
Tommy D Posted March 19, 2006 Report Share Posted March 19, 2006 I have been using 3* cant/lift disks on TD1 bindings. I'll probably try 0* disks to see what it feels like. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.