Guest eladius Posted February 8, 2005 Report Share Posted February 8, 2005 Hello, Just bought a pair of raichle sb 413 to attempt some carving. I also bought some burton physics carrier bindings that have the intec. Are these compatible? Can I install the intecs on these boots? I shoulda checked before I bought but didn't know the difference. TIA::rolleyes: Quote Link to comment Share on other sites More sharing options...
Aracan Posted February 8, 2005 Report Share Posted February 8, 2005 Are you sure your Burton binding is an Intec binding and not the Burton-specific Physics system? If yes, your Raichles should fit in. If it's Physics, then I am afraid they won't fit. Quote Link to comment Share on other sites More sharing options...
Hugh Posted February 8, 2005 Report Share Posted February 8, 2005 Answer to your question: Yes, 413's are Intec compatible. There are pre-drilled holes on the inside the boot (outside edge) of each heel for the cable to run through. Only the screws that come with the heels will mount them. --Hugh Quote Link to comment Share on other sites More sharing options...
Guest eladius Posted February 8, 2005 Report Share Posted February 8, 2005 I've got the burton carrier physics which the instructions say are intec compatible and comes with intec heel replacements. I'll swap them out on my boots! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.