ibrussell
-
Posts
469 -
Joined
-
Last visited
-
Days Won
5
Content Type
Blogs
Gallery
Downloads
Store
Events
Profiles
Forums
Posts posted by ibrussell
-
-
If you are looking at Raichle/Deeluxe they have the boot sole length near the heal a 295mm is a mondo 27-27.5 comfy, Not sure of 289/285mm sole 26-26.5 I can fit a 27.3 foot in these with the molded liner more of a race fit. Then there are two sizes inside boot cuff. Upper and lower, The lower is the one you need to look at for size. I have a set of 277mm sole with upper cuff of 27/27.5 lower of 25/25.5 that fit a mondo 26/26.5
-
Wait till summer when it's hot, put a 1x4 maybe trim a 1x6 as long as the warped part of the base. Trim a 1x12 board width for the warp on top, 4 2x4's cut 3" wider than the board to sandwich top/bottom boards than clamp with adj clamps. tighten, tighten again in a 1/2 hours. Leave for 24 hours check redo if not flat. Did this on an old Burton that was concave worse than that, took two 100 deg days . Flatten 99%+ enough to run flat on cat tracks. It's been two years and still flat. I'd grind it 100% flat but it's a old Burton rock board. Always on the cutting Edge....of obsolete.
-
1
-
-
Thanks everyone for your thoughts. After 13 day of iffy ICU and a number of days on different wards, I'm home and alive. Still looking at 1-2 months to get all the tubes out, but will be on the snow next year. Charlie
-
1
-
1
-
-
My husband Charlie Russell asked me to post something for him here; he took a tree branch to the abdomen on Friday Dec. 22 while riding powder in the trees at Brundage Mountain in Idaho, and is still in the ICU after two surgeries. He is expected to make a full recovery in roughly 7 weeks, but it'll put a serious damper on some early-season plans. Charlie was deep in the trees when he got injured, and after no one heard him shouting for about 5 minutes, he got up and finished the run, went to the car, put up his board, changed out of his boots and went to the ski patrol room. Five minutes later, as I headed to the car to meet him for lunch, the patrol flagged me down and we were off to the ER. Charlie's injury was a traumatic abdominal wall hernia, and the initial scans showed no internal injuries despite something big and very obviously wrong in the form of a pretty bizarre looking bulge on his stomach. The internal injuries showed up later; he had a portion of his small intestine removed. The current part, recovering from the surgeries, really sucks, but it should get better soon.
-
2
-
-
Board is Sold
-
Interested in the boots. Shipping for the boots to 83702?
-
When I start washing out or skipping the tail I rotate the back binding forward to take off the extra heel pressure causing the washout.
-
One pair of black TD2's SOLD
-
I have two pair of 3hole TD2's center disks and one TD3's center disk. $37 each shipped in con. U.S.
-
in pic 1 that setup would give you 5-6 deg heel lift. padded piece on heel non on toe. My TI's pads like those are flat whit no pads on either. when you have bindings on the board and step in the toe bail should be more forward than pictured to step almost straight down. Yes you can use fintec with intc heels but the heels will wear faster.
-
SOLD 175 F2 Speedster RS WorldCup 5-6 quarter/half days too soft for me at 185# F2 weigh 60kg + (152#) nose 24.3 waist 188.4 tail 22 some light small rash on tip from moving and storing, and a small nick on top near tail. can't get good pic because it's small. $250 plus shipping SOLD
-
Board got here in great shape, Thanks Now just need the snow. ib
-
Stoked and sore, Just got off the hill, with me and my chain saw, making a few pirated runs for those powder days. May they be as good as last year. I can always carve it does't snow every day.
-
I'll take it shipping to 83702
-
1
-
-
Deeluxe 325 boots mondo 25 US 7 excellent shape 277 boot sole liner never molded. $200 shipped in con U.S.
-
Brundage has four or five intermediate runs they keep groomed even on most powder days. They mostly funnel back to the same lift or a slow fixed triple. No lines but I got bored after skiing there 5-6 times over 6 years, but maybe it was because it is a 2.5 hour drive each way to ski for 4-5 hours. There were one -two other carvers a few years back but haven't seen any the last 2 years I've been there. Open 9:30-4:30 they are know for their powder in Jan.-Feb, although only 4" to 1.5' mostly. McCall is a 25-30 minute drive, The last six miles are 25mph switchbacks. I'd say Bogus basin 16 miles of switchbacks from Boise but it takes 35-45 minutes and they open late on weekdays 10am-10pm, 9-10 weekends, but passes are $350 if you just moved here.
-
Play it again sports in the Sugar House district gets some stuff but its real hit and miss. I'd call before going over.
-
SOLD 177 Donek axxess 21.5 waist 10.5-12.5 side cut only 10 half/quarter day on it. Too stiff for me at #180. $550 shipped Too stiff for me at 180# $550 shipped in lower 48
-
What's the sole size of both the boots? Thanks
-
-
Yes We ran a set of 205/55/16 off my son's impreza on our 2013 outback for the last two years, worked great but like Corey said the speedo said we were going 5 mph faster than we were and it lowered the clearance by about 1.5".
-
I did option 1 in a kitchen. Didn't change temp in the room much, but everyone would work next to it in the winter to have extra warm feet.
-
1
-
-
What size? What is the sole length?
-
It does not impair riding, my son couldn't feel any difference. It is just under the calf padding and above the ankle hold down padding. USPS Shipping from 83702 12# 18" x 14" x 6" looks like $65.55
stance location relative to vscr?
in Carving Central
Posted
Move the front binding forward 1/8-1-4" try it move it forward 1/8-14 again until it turns too much or hooks, then back off until it feels right..