Powder Rider

I am looking forward to riding with you all at MCC! This will be my first time at MCC. I am especially interested in the clinics and trying to lay out some euro carves! I started as a hard booter in 1989 with a Burton PJ 170 AYSM board and have enjoyed carving since then. Looking forward to meeting you all.

Barry J, Thank you for your input on the Donek F plate and the Rev 163. I ordered some Bomber Sidewinders BP bindings. Looking forward to setting up the Rev with the SW bindings and the F Plate for carving at the Montucky Clear Cut. I paid $218 for the F Plate on Gear Trade. I wish I had found this forum before making my recent purchases.

Is the Bomber plate still available for sale?

My first time going to Montucky Clear CUT! Hopefully, there will be enough snow for Turner Mountain to open, and MCC is a go! What is the road to Turner Mountain like? Will a rear-wheeled van be able to get up to Turner Mountain with all-season tires from Libby? I have snow chains, but I prefer not to use them. I can rent an AWD SUV as an option. Is there a shuttle bus to Turner Mountain?

Hello, fellow Carvers, I am preparing for the 2024 Montucky Clear CUT and purchased a REV 163 UPM from eBay and a Donek F Plate from Gear Trade. The Donek F Plate (UPM version). The F Plate came with eight oval nuts. What are these oval nuts used for? The F Plate did not come with any instructions. Does anyone have a set of instructions for mounting the Donek F Plate (UPM version) to the Rev 163? FYI: I wish I had found this forum before making my purchases. Kind Regards, Powder Rider