Have recently filed and polished my edges but they still dont feel that sharp, any ideas?
I did the fingernail test and some was shaved off, but it did not come off as easily as on my Prior WCR which was tuned (assume ground) at 90 deg at a local shop.
I did my coiler all mtn with a 1 deg base and 2 deg side, with an Fk MT701 multituner using the std file and red, blue & black diamond stones. Process was:
1) Base edge then side edge as below
2) Black / Blue diamond to De-Burr / Remove Rust.
3) File edges.
4) Polish edges with Black (rough), Blue then Red (Fine) stones until edges are smooth to the touch and eye.
Took about 30min each edge, used water also.
The problem could be that when i filed the base with the mill file not much material seemed to be removed - i put this down to the base being too high, ie the tool rubbing on the base instead of the edge.
I have read past threads where the edges were so sharp people had apparently cut themselves, how sharp is sharp enough?
I am wary of taking too much material off the edge so dont want to file too often.