Jump to content
Note to New Members ×

Old Blax Bindings Boot fitment issues.


Recommended Posts

I got an old set of Blax bindings. The toe block is metal. The center disk is held onto the base with 4 screws so you can undo them to adjust the angle. Issue I'm having is that my size 26.0 323s seem to just fit with the toe and heel blocks set all the way towards the center. I think they are tight enough but I'm worried about them losening up if it's cold out. Can I just wrap a little tape around the heel bale to snug them up some? I'm using these bindings on an old O2 Apex 165 as an AM rock board so I won't be doing any hard carving with them. Just don't want to experience an early release :freak3:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing

    • No registered users viewing this page.
  • Create New...