Been riding the CODA quite a bit lately. A few days ago I was prepared to say that production imperfections were long forgotten and acknowledge to the forum that my skwal riding has improved immensely with the softer flex and the 10m sidecut since receiving the CODA - which it has.
The most recent problem, my CODA 4x4 insert hole pattern is off kilter not allowing binding screws to sit properly within my CATEK lower plate 4x4 pattern. Also, the insert depth below the surface of the board is so great that it will not allow one to obtain a three full thread turn engagement. Last night I discovered two of my front binding insert screws were totally loose. I consider myself lucky that I only lost an elastomer and that the front binding itself didn't tear completely off the board.