Jump to content

Burton circular 3D cants for sale...


tahoecarver
 Share

Recommended Posts

All the ones I had of these had holes drilled for use on either a Burton Board (3D) or on a standard 4x4. The upper plate, where the binding plate actually interfaced, was only the 3D. So if you mounted the Burton Adjusty Cant on a 4x4 board, you needed a 4x4 disk for the front binding, but a 3D disk for the rear binding, as it interfaced with the Burton Cant.

Link to comment
Share on other sites

I thought most carvers or riders would know this (especially East Coast riders), but I guess my assumption is incorrect...3D is Burton's proprietary insert pattern, with 3 holes in a triangular configuration. 4x4 is the 4 hole square pattern the rest of the snowboarding world uses. I am advertising 3D cants, all at 7 degrees. Thanks.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...