Jump to content

Play in TD2 Cant Disk


fluxgame
 Share

Recommended Posts

Was messing around with my stance yesterday evening (because what else do you do when you just registered for MCC and there's no snow yet?) and noticed that the cant disk on my rear binding has a bit of play in it. The center disk is tight to the board, but the cant disk isn't. Do the e-rings eventually compress and need to be replaced?

Edited by fluxgame
Link to comment
Share on other sites

  • fluxgame changed the title to Play in TD2 Cant Disk
46 minutes ago, ibrussell said:

With binding off board is there any play between the teeth of the cant and the disk as on might be worn or warped.

Yes, there's a bit of play between the two. But I assume the tolerances on these parts isn't that tight and relies on the compression of the rubber e-ring for holding everything in place? The front one has the same amount of play and doesn't budge once it's all snugged up.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...