scrapster Posted December 30, 2009 Report Share Posted December 30, 2009 Hey, Anybody know how to change the canting on Snowpro bindings? I have the extra cant wedges, just not sure how to get them in there. Thanks! Quote Link to comment Share on other sites More sharing options...
BlueB Posted December 30, 2009 Report Share Posted December 30, 2009 Mark, it is a bit of work to get there, but not too bad. Keep turning the length adjustment screw on toe/heel block until the 2 of the hold-down screws are showing. Undo those 2, then push the block all the way to the other direction to find the other 2. After all 4 (per block) are undone, pull it appart and add in the canting/lifting shims. Make sure that you use the screws of correct length for the new setup. Too long and you'll damage the top sheet, too short and it would strip the tread. I hope it helps. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.