fishrising Posted September 13, 2004 Report Share Posted September 13, 2004 Will intecs work with Burton Wind (I think) boots? They are the blue red and clear shelled Burtons (blue liners), I am guessing they are of 2001 or 2002 vintage...they have removable heels. Can you still use intec heels in standard bindings? Thanks in advance! Ben Quote Link to comment Share on other sites More sharing options...
fin Posted September 13, 2004 Report Share Posted September 13, 2004 Ben, There are others here with WAY more Burton boots knowledge then I but I am going to say that generation of Burton is compatible with Intecs. Yes, you can use Intec heels in regular bindings. Putting Intecs on your boots keeps them "back compatible" and they will still work in regular bindings as well as step-ins. Ciao! Quote Link to comment Share on other sites More sharing options...
Mellow Yellow Posted September 13, 2004 Report Share Posted September 13, 2004 You should be able to use the intec heels with the Winds. If I am not mistaken, you can adjust the heel and toe piece on the Winds to a compact mode (no heel or toe lip) or you could move the heel and toe out. I used to ride with the toe lip out and the heel piece in with my TD1 step-ins Quote Link to comment Share on other sites More sharing options...
bobdea Posted September 14, 2004 Report Share Posted September 14, 2004 accept intec as well as the other two types stepin heels you may find out there you can retract the whole heel ledge if you use intec with burton boots if you get the burton physics binding you can retract the toe ledge as well which is quite nice if you have big feet the older boots like the boiler and furnace cannot use intec Quote Link to comment Share on other sites More sharing options...
fishrising Posted September 14, 2004 Author Report Share Posted September 14, 2004 Thanks to all for the info! Hey Fin, when will the TD1 retro kits for intecs be available? Should I put an order in now, or wait? The store site says they are sold out until the fall... Any one know about converting SnowPro RACE LTDs to intec compatible? Quote Link to comment Share on other sites More sharing options...
Jon Dahl Posted September 14, 2004 Report Share Posted September 14, 2004 but here goes. The fast step-in system has a slightly different bolt pattern at the base plate than the intec heel piece for the binding. The standards probably cannot be done, also, and I don't think I'd like to redrill the snowpro base 'cause it's so thin, and I like life and limb. Just anty up and buy some TD2's and live! Quote Link to comment Share on other sites More sharing options...
fishrising Posted September 15, 2004 Author Report Share Posted September 15, 2004 Sorry Fin, I just opened my eyes and read the first line on the Bomber store page..."New Stock Will be Available in November." Can I still add the TD1 retro kit to my cart and checkout? Or, should I wait until they are in stock? Quote Link to comment Share on other sites More sharing options...
fin Posted September 15, 2004 Report Share Posted September 15, 2004 fishrising, Your best bet is to just contact us in November and we'll get you going then. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.