Catek OS Bindings help

[holiday01]

Does anyone know if there is a manual for these bindings available online somewhere. Or will the OS2 Manual help enough.

[DiveBomber]

Does anyone know if there is a manual for these bindings available online somewhere. Or will the OS2 Manual help enough.

heres the short version: Get allen wrench, insert, turn as needed. Rinse, repeat.

[RDY_2_Carve]

I believe www.alpinecarving.com has an extensive writeup on OS2 bindings. I would check that out first. That should give you the jist of what you're looking for assuming you DON'T have OS2's. I believe the idea is pretty simple for Catek's though: Set your Cant/Lift combo based on the outer screws then tighten down the Kingpin to set it in stone.

[holiday01]

I have a short and a long pair on the way, when they get here I'm sure I'll be posting again looking for some help.

I've only seen one guy at my local hill, and I think he has a pair so maybe if I can catch him, he'll be able to help.

[Willow 15]

www.alpinecarving.com/wtc06/add/ I found this very helpful. All you have to figure out is cant and lift.

[Chris Houghton]

Remember to tighten the center bolt first, with the four cant screws still loose. If you do it the other way around, there's a good chance (risk) that the center bolt may come loose. After the center bolt is tight, set your lift and cant, taking up the slack with the four setscrews. After they are all touching, tighten them another half to three quarters of a turn.

If you can't find the instructions online at Catek's site, e mail me and I'll scan and send them to you (I think I have a paper copy somewhere).